Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 4/3/2006 3:13:06 PM EDT
OK, I have my 12 ton HF H-frame press and my barrel pin removal adapter. I whip out my parts kits and go to town on the barrels. I did two for my brother in law and three of my eight barrels and call it a night. I get up to do my five remaining barrels and notice that I have seriously screwed the pooch. One sight base is fubar and the other five are leaning. Not bent, but canted to one side.

So, my noob ass needs to know, apparently in terms an idiot can clearly understand:

1) How do you support the barrel/trunion/rear sight block on a Romanian G kit before attempting to press out the barrel pin.

2) How do you fix canted rear sight blocks?

Many thanks!
Top Top