Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/3/2006 4:32:16 AM EST
[Last Edit: 3/3/2006 4:37:03 AM EST by arcom]
AIM kit, screw build Ewbanks receiver finished in AlumaHyde, Romy folding stock from a group buy ($50) that was a 100% drop in fit with the original Romy rear trunnion and was of course welded in the open position to meet NY law, Scout Mount (works great, best mount I've found so far), $20 red dot that didn't break after 100 rds, Russian dog tag inlaid into fore grip where a factory repair to the wood fell out. Looks hokey in the picture but looks much worse close up. Not a perfect build but runs like an AK should. Had to grind a smidge off the rear of the hammer where it would bind with the bottom of the bolt carrier. I think this is not uncommon with the TAPCO hammer from what others have posted.

Link Posted: 3/3/2006 7:19:10 AM EST
Nice looking build arcom, glad it runs good.
Link Posted: 3/3/2006 10:02:50 AM EST
[Last Edit: 3/3/2006 10:27:28 AM EST by shootdaily]
Looks great
(was of course welded in the open position to meet NY law)
that stinks. heard
Glad I don't have any laws like that. h.gif
Link Posted: 3/3/2006 5:26:44 PM EST
That came out real nice. How much for the Scope Mount and where did you get the wood PG

Link Posted: 3/3/2006 6:34:47 PM EST
[Last Edit: 3/3/2006 6:36:36 PM EST by arcom]
Scope mount was about $60...a bit much but the best one I've used. The pistol grip came from one of the walnut milled receiver stock sets AIM sold a while back. NY assault weapon ban does not allow folding stocks on any post '94 rifles---same as the now defunct federal law.
Top Top