Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
1/16/2020 9:48:49 PM
Posted: 12/28/2006 3:54:06 PM EST
Whats the best way to drill the front rivet holes for the trunion on the DCI 100% receivers? (for a bulgy side folder)
Link Posted: 12/28/2006 4:12:20 PM EST
Are you asking how to locate the holes? socandyman's tape method work's well.
If you're asking what to use to drill them, I recommend a drill press.
Link Posted: 12/28/2006 6:00:07 PM EST
[Last Edit: 12/28/2006 6:06:46 PM EST by mstrsippy]
are you locating holes for the front trunion or the rear?
Link Posted: 12/29/2006 1:34:49 PM EST
Make one of these Rivet locator
Link Posted: 1/1/2007 5:38:59 AM EST
How much "egging" can you get away with?
Obviously none is preferred, but I have a
front trunion hole (the 2nd from the front)
0n one side that I had to work to get the
rivet through. The rivet head hides the hole,
but it is a little egged. Should I worry too much.
I mean, I don't know of a way to fix it.
Link Posted: 1/1/2007 6:34:40 AM EST
Link Posted: 1/2/2007 2:40:01 PM EST
my polish trunion has two on one side that are a little egged.
i guess they wherent taking thier time during the demil phase.

do they have oversized rivets ?
if that had to be the way to go ?
Link Posted: 1/2/2007 5:42:32 PM EST
Actually, I don't think I was clear.
The hole in the receiver is a bit
egged, not in the trunion itself.
Should I be concerned?
Link Posted: 1/2/2007 6:13:27 PM EST
not sure, i know they have over size rivets.
Top Top