Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 1/8/2006 1:54:58 PM EST
Just finished my Maadi with Moly Resin. I love that stuff now!



I was wondering if I have the retention spring installed correctly.




I purchased the gun for $250. It has some odd stuff like the front sight post, and the upper gas tube but I think its not bad for a franken gun.

Link Posted: 1/8/2006 1:57:28 PM EST
looks nice! the retainer is in correctly
Link Posted: 1/8/2006 1:58:51 PM EST
Good job.
Link Posted: 1/8/2006 2:00:45 PM EST
Looks good man. I've thought about getting a maadi to be a beater AK.
Link Posted: 1/8/2006 2:21:24 PM EST
Link Posted: 1/8/2006 2:37:22 PM EST
[Last Edit: 1/8/2006 2:45:34 PM EST by HUNGARYAN]
Nice job!

Wonder why someone changed out the ribbed receiver cover for a chinese version.

Edit: Are you certain that is a Maadi?

I am holding my RML here comparing the picture to my rifle, seems like some differences going on(other than the obvious) up front, the sight assm. looks different, the gas block also.

Just wondering.
Link Posted: 1/8/2006 2:48:14 PM EST
Misr?
Link Posted: 1/8/2006 4:30:28 PM EST
Great looking rifle. Looks like from the photo that you don't have the retainer spring in the groove of the rear most pin. (Of course I could be wrong). Lift the spring up and see if you can seat the rear pin in a little more and drop the spring in the groove. I did that once, did not notice and went shooting. Caused my trigger to come apart. Even with half my trigger assembly hanging out the AK still fired. What a rifle !!!
Link Posted: 1/8/2006 5:04:34 PM EST
Very nice looking piece!
Link Posted: 1/8/2006 5:53:33 PM EST
Yes its a Maadi ARM... Stamped INTRAC, AND!!! Styer... It was overstamped by INTRAC


I think someone used the Maadi Reciever to build a kit of some sort.. I don't know for sure but it looks like they did good work.
Top Top