Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 3/11/2005 9:02:51 AM EST
[Last Edit: 3/11/2005 9:04:01 AM EST by hugboy]
I'm just getting ready to bend my flat and looking at the blueprint is't clear what does it need
to be measurement wise from the top to the bottom, I need to be clear if that is measured from inside to top or outside to to outside on my print it shows it to be 1.700 on the back
and 1.250 on the front but is that outside or inside ? HELP!!!!!!!!
Link Posted: 3/11/2005 10:40:53 AM EST
the inside should be 1.25 all the way thru
Link Posted: 3/11/2005 10:54:29 AM EST
The 1.25" is the inside mesurement for the width of the receiver along the bottom. I do not know the measurements for the height of the sides, except that the rear is taller than the front.
Link Posted: 3/11/2005 11:03:08 AM EST
[Last Edit: 3/11/2005 11:06:23 AM EST by hugboy]
The measurement of the heigth of the sides is what i need
Link Posted: 3/11/2005 12:15:31 PM EST
check this out, you are going to have to register to see it, (free) but it should have all your measurements you need.
gunco
Link Posted: 3/12/2005 5:23:06 PM EST


Link Posted: 3/14/2005 1:40:19 PM EST
Top Top