Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 8/10/2003 9:55:49 AM EST
What size drill bit do I need to install the K-var US polymer buttstock?
Link Posted: 8/10/2003 11:24:28 AM EST
I don't remember exactly what size drill bit I used, but I do remember that I figured it out by comparing the screws to various bits and finding one slightly smaller in diameter. Hope that helps.
Link Posted: 8/10/2003 12:19:47 PM EST
Did you judge by the width of the threads or the width of the shaft of the screw in side the threads?
Link Posted: 8/10/2003 1:26:19 PM EST
I tried to get it slightly smaller then the width of the threads. If it's made to tight you might find yourself later unable to get the screws out. I had to destroy a K-var plum buttstock to get it off once because of overly tight screw holes.
Link Posted: 8/10/2003 5:15:09 PM EST
Top Top