Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 12/18/2005 7:26:38 AM EDT
I took them out and this summabitch still doesn't want to come off----any suggestions---I read a post about this a while back but can't find it---thanks
Link Posted: 12/18/2005 7:39:31 AM EDT
Take out the two screws, put the trunion in a vise, smack the stock with a mallet.

It is an AK afterall.

SRM
Link Posted: 12/18/2005 7:59:47 AM EDT
Remove the bolt carrier and use a socket extention to beat it out from the inside. It also helps sometimes to smack it with your palm at a 45 downward angle. Smack one side and then the other. Alternate smacking on the outside and pounding from the inside.
Link Posted: 12/18/2005 9:36:37 AM EDT
the romy rear tang has a nice big hole in it that makes a great place to stick a prybar, the stock comes out easily that way. or if it is a kit, just grind the rivets off and take it out the stock after you peel the stub open
Link Posted: 12/18/2005 3:10:52 PM EDT
I've found that grinding the rivets down and bending the sides free will let the stock loose. Appearently, the stock is REALLY tight fit.

Before I just popped the sides off the rivets, I tried banging the receiver stub with a deadblow and a ballpeen hammer. The prybar method didn't work either, and cost me a screwdriver.

John
Link Posted: 12/18/2005 4:01:52 PM EDT
grind the rivets off then peel the receiver off.

if you pry and pound, there's a good chance you're damage the stock.

Caspian
Link Posted: 12/18/2005 5:57:27 PM EDT
i did mine like Caspian45 said and had good results
Top Top