Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/22/2017 10:05:29 PM
Posted: 9/23/2004 8:32:01 AM EST
How has the rivet for the mag release? I had to drill mine out and need a replacement. Thanks
Link Posted: 9/23/2004 2:50:08 PM EST
Link Posted: 9/23/2004 4:47:22 PM EST
Do they make pop rivets long enough?
Link Posted: 9/24/2004 7:22:31 PM EST
Global Trades has them, and i believe K-Var does as well. You might also try AA-OK
Link Posted: 9/25/2004 8:01:28 AM EST
Anyone know how the hell to get the mag release spring to go back into place after it is removed? I have tried and tried, but just can't get it. What is the trick? Thanks

Link Posted: 9/25/2004 9:40:46 AM EST
Here's how I did it.

1) Make a pin that is just as wide as the lever. (use a nail, drill shank, whatever is handy)

2) Position the spring inside the lever and install the pin.

3) Position the lever/spring /pin assembly in the trigger guard.

4) Push the homemade pin out with the lever pivot pin.

5) Flare the ends of the pin over with a blunt punch to retain pin in guard.
Link Posted: 9/25/2004 12:52:51 PM EST
[Last Edit: 9/25/2004 1:50:36 PM EST by millsusaf]

Originally Posted By coyote3:
Here's how I did it.

1) Make a pin that is just as wide as the lever. (use a nail, drill shank, whatever is handy)

2) Position the spring inside the lever and install the pin.

3) Position the lever/spring /pin assembly in the trigger guard.

4) Push the homemade pin out with the lever pivot pin.

5) Flare the ends of the pin over with a blunt punch to retain pin in guard.



Genius, genius I tell you. Thank you very much!

*Added* Worked like a champ! I just have to get a rivet now. But until then my punch will work.
Top Top