Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 2/7/2006 12:47:23 PM EST
I have a new 5.56 bolt and I am installing it in a AK74 trunion..

I have a new 223 bullet guide..but it looks almost identicle to the one in it.

The bullet guide that is currently in it looks like it will work, but my bolt will not go into the trunion far enough to rotate and close..it is binding about 1/8 of an inch before rotating to lock up. It appears to be catching on the bullet guide on the bottom side..left.

I could take a little off the guide, but theres not much there to begin with.

I was wondering if it would be OK to modify the bolt lug by filing it down just a bit to allow lock up. I would only need to take off very little on the lug itself...maybe 1/16.

I was wondering if I should take it off the front at an angle...or off the top of the back(there is already an angle there..I was just going to exagerate it.

Lets here your opinions..

Trunion is not in reciever, and barrell is not in trunion yet.


Link Posted: 2/7/2006 1:55:05 PM EST
Top Top