Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 8/10/2005 6:27:27 PM EDT
[Last Edit: 8/10/2005 7:22:05 PM EDT by basko152]
I was drilling out rivets tonight and accidently egg-shaped one of the top front trunion rivet holes

Is this going to be a problem. This is my first f#%k up on the trunion, so I want to proceed carefully. It was only one hole and the rivet will still seat, but with barely perceptible play.

Ideas or help?
Link Posted: 8/10/2005 7:04:41 PM EDT
socandyman told me that this shouldn't be a problem since the rivet will fill in the egg shaped hole when it is pressed. Two of the rear trunnion holes on my Polish underfolder kit came this way.
Link Posted: 8/10/2005 7:18:38 PM EDT
That is good to hear and it does make sense that the soft rivet will fill it up and hold things tight.

Here is a pic to explain it better. I'm hoping this isn't too severe, even for the front trunion.

Link Posted: 8/10/2005 7:29:11 PM EDT
thats nothing at all, dont even worry about it
Link Posted: 8/10/2005 8:57:59 PM EDT
Don't worry about it...
Link Posted: 8/10/2005 10:18:28 PM EDT
That's nothing.

I've done one helluva lot worse and gotten away with it.

Don't worry about it. The rivet shaft will swell when compressed and will more than take up the minute slack you have there.
Top Top