Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 2/20/2006 10:35:52 AM EST
This Yugo kit is breaking my tool allowance. Three punches, heat, freezing, a BFH and I finally won. Beat them until they give.
Link Posted: 2/20/2006 10:37:57 AM EST
Hope that picture wasnt taken on the flving room floor.
Link Posted: 2/20/2006 10:51:28 AM EST

Originally Posted By BJohnson383:
Hope that picture wasnt taken on the flving room floor.



Nope...just a towel covering the kit out on the bench. The wife gives me all the old ones so I can mop up oil and such.
Link Posted: 2/20/2006 10:54:47 AM EST
#1...Dasco pro punches SUCK!

#2...You're doing something wrong!
Link Posted: 2/20/2006 11:03:32 AM EST
[Last Edit: 2/20/2006 11:04:03 AM EST by corny]
Here's how it goes. Drilled all the way through with the biggest bit without messing up the trunnion. I was peeling the edges in so I could start knocking it out and the piece of crap punch snapped off in the hole (that's where the problem started). I knocked the other rivet out in about 2 minutes. The one with the punch broken off in it was a bear. I redrilled it and broke another piece of crap Dacso punch off again. This time there was enough to pull it out. This is only the second kit I disassembled. Waiting for the receivers so I can start assembly. If there is some secret trick I am all ears. Who makes good punches?
Link Posted: 2/20/2006 12:11:37 PM EST
[Last Edit: 2/20/2006 1:14:57 PM EST by bryan666999]
I drill through the center of the rivet with a 1/8 bit. Then I step up a to a 5/64 or #21 which is smaller than the rivet yet, but I drill VERY SLOW and with lots of pressure. The bit will grap the rivet, spin it and push out.
Link Posted: 2/20/2006 12:35:25 PM EST
That sounds like a plan on the next build.
Thanks
Link Posted: 2/20/2006 1:13:48 PM EST
Actually, let me take back the size. The size to use after 1/8 is 5/64 or a #21. Sorry bout that
Link Posted: 2/20/2006 3:21:49 PM EST

Originally Posted By corny:
Who makes good punches?



I have a set of the Sears Craftsment that have held up fairly well.

thanks,
Ron
Top Top