Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 9/8/2004 6:56:31 AM EST
Hello, everyone. I am thinking about purchasing one of those new fancy, dancy, "match grade" US made gas pistons by Arsenal of Nevada. "Match Grade," I cant get over that!!!! Anyway, how hard would this be to install on my Polytech 7.62? I can see the pin going through the bolt carrier on my Poly, so I dont think there is any weld to have to get through, etc. Do I just hammer the pin out with a punch? On installing a new one, do I just screw it into the carrier, leave a little play in the piston/carrier fit, mark where the hole will need to be in the piston, and drill it, then screw the piston back into the carrier and drive the pin in? Or am I making it too simple? Thanks in advance for replies.
Link Posted: 9/8/2004 9:20:42 AM EST
[Last Edit: 9/9/2004 4:18:05 AM EST by CAMPYBOB]
Link Posted: 9/8/2004 9:20:43 AM EST
[Last Edit: 9/8/2004 10:23:48 AM EST by CAMPYBOB]
Link Posted: 9/9/2004 3:23:27 AM EST
Thanks campy bob. That should get me on my way!
Link Posted: 9/20/2004 8:01:13 AM EST
Where can I get the pin at? Tapco didn't bother to send me one with mine.
Top Top