Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
PSA
Member Login

Site Notices
Posted: 10/8/2005 4:01:30 AM EDT
I have to install A FCG without the sleave that makes it easier.  Can anyone direct me to instructions?  Thanks as always!
Link Posted: 10/8/2005 5:59:51 AM EDT
Here you go. I'm sure everyone does a few things a little different.
FCG install
Link Posted: 10/8/2005 6:09:11 AM EDT
If your installing a G2 FCG you need the sleeve that comes with it to make it work right.
Link Posted: 10/8/2005 6:14:57 AM EDT
I have an FEG not a G2, any difference..it does not have a sleeve.
Link Posted: 10/8/2005 6:36:29 AM EDT
Not all FCG use the sleeve. There are even some earlier G2s that don't use them. Just stick the trigger pin through the trigger holes. If its a tight fit, then no sleeve is required. If it wobbles around then you need a sleeve.
Link Posted: 10/8/2005 3:20:26 PM EDT
So that's what that left over part was
Link Posted: 10/8/2005 5:19:08 PM EDT
some FCGs have a spacing washer, I have two kits that have the washer, not sure where it goes between on the pin though
Link Posted: 10/8/2005 6:36:43 PM EDT

Originally Posted By 1Gunner:
some FCGs have a spacing washer, I have two kits that have the washer, not sure where it goes between on the pin though



It goes on the right. It keeps the Disconnector to the left over the spring indent on the trigger.
Link Posted: 10/8/2005 6:56:22 PM EDT
www.gunsnet.net/Linx310/index.shtml

Lots of how to on Linx310's site
Link Posted: 10/8/2005 7:26:09 PM EDT

Originally Posted By Jerret:

Originally Posted By 1Gunner:
some FCGs have a spacing washer, I have two kits that have the washer, not sure where it goes between on the pin though



It goes on the right. It keeps the Disconnector to the left over the spring indent on the trigger.



duely noted, thank you very much
Top Top