Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 1/7/2006 4:03:48 AM EST
Does anyone have a description of the home built AK/SKS sight adjustment tool?

Link Posted: 1/7/2006 6:24:22 AM EST
[Last Edit: 1/7/2006 8:53:17 AM EST by sleepercaprice1]
Yeah, I made a couple years ago. I used a 1/4" bolt partially threaded, maybe 4" long. I cut a notch in the threaded end with a hacksaw and doubled up blades so the notch would fit over the flats on the sight post. I then screwed a nut onto the bolt over the notch and brazed it in place. Then, I ground off most of the nut so it just left a collar aound the notched bolt. When I had the nut ground down far enough to fit in between the ears on the AK, I bent the bolt into a 90 degree angle. It works fine and didn't take more than a few minutes to make.
Link Posted: 1/7/2006 6:25:28 AM EST
a crimped 5.56 case does the same thing, just won't last as long. (if just for the post elevation, etc.)
Link Posted: 1/7/2006 8:40:10 AM EST
Anyone make a tool to drift the sight?
Link Posted: 1/7/2006 8:55:06 AM EST

Originally Posted By Stove_Pipe:
Anyone make a tool to drift the sight?

I just use a piece of wood dowel rod and a small hammer. You could easily make a tool with a small C clamp and a short metal sleeve that would fit over the end of the pin. Get it?
Link Posted: 1/7/2006 11:39:39 AM EST
Thanks guys for the responses!

Great help!
Link Posted: 1/7/2006 11:51:04 AM EST
Photo's please. Thanks.
Link Posted: 1/9/2006 5:59:03 PM EST
Got it, Duh! I feel dumb now.
Link Posted: 1/10/2006 5:53:49 PM EST
One AK had paint or rust that made it very hard to screw up or down, after breaking two adjustment tools (standard type and the blue colored one) used a nice needle nose pliers and it works good.
Top Top