Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 11/23/2003 4:57:21 PM EST
Can you beleive I bought that height guage and a whole tool chest at a pawn shop for 125.00. There was a 0"-6" depth mic. set. A set of std mics. 1"-4". A butt load of taps a full set of tap guages. Four sets of 123 blocks and an angle plate. A shit load more that I can't remember.
I got the surface plate at the same auction I bought my lathe at. I bought a couple of shop tables for 50.00 and the plate has a wood top for it and it was one of the tables. I guess I get lucky some times.
Link Posted: 11/23/2003 5:00:27 PM EST
Link Posted: 11/23/2003 5:29:20 PM EST
I've had all this before I ever heard of the gooch. I've had a small shop for years.
Link Posted: 11/23/2003 5:32:52 PM EST
Link Posted: 11/24/2003 3:32:52 AM EST
Link Posted: 11/24/2003 5:47:40 AM EST
I got my Enterprise for 1800.00 it cuts metric. It also came with a collet chuck set up and shit loads of tooling. It came from a factory that built microphones. It was used very little. It was three phase though. I used a static converter but it was 6hp to begin with.
Link Posted: 11/24/2003 8:09:14 AM EST
Top Top