Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 9/21/2005 8:02:23 AM EDT
[Last Edit: 9/21/2005 8:02:49 AM EDT by Quarterbore]
I was fighting with the headspace of my AMD-65 kit last night and I decided I need to make some type of handle or knob for the pressure relief nut on my jack... Fighting with that handle just got to me last night...

Has anybody looked to see what would work?

I figure I will get some measurements and head down to the hardware and see if I can find some type of handle that I can fit to the jack... I must not be the only person that has got tired of fighting with that stupid handle and this way I can just keep the jack handle where it belongs as well...

At worst I will find a short piece of hollow stock and make a handle for just this job...
Link Posted: 9/21/2005 8:37:19 AM EDT
Dang!!!! That's a great idea. I hate the little "T" screw. Putting a knob on it would be moosemeat!!!!!
Link Posted: 9/21/2005 5:09:09 PM EDT
i'm with you on that. i have an old tap holder tool that just might fit right on there
Link Posted: 9/21/2005 5:51:58 PM EDT
I just got back from shopping... I got a handle that looks like the perfect solution.. I will upload a pic in a minute after I see if it works...

I'll be back!
Link Posted: 9/21/2005 6:37:51 PM EDT
[Last Edit: 9/21/2005 6:39:01 PM EDT by Quarterbore]
Wow is that great... I spent $7 for a 2-pack (Now I need to buy a "C" press somewhere and it took about five minutes to install...


Check out my "H" handled "H-Press"



Here are the details:

www.quarterbore.net/forums/showthread.php?t=550
Top Top