Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/22/2017 10:05:29 PM
Posted: 10/15/2004 6:02:07 PM EST
I have purchased a Muzzle Break for my WASR-10 and I need to install it. I can't tell which side to knock the taper pin out from. Can someone help me on this?? The dealer I purchased it from notched it out on the bottom so it will fit around the Cleaning Rod Holder and I have all the tools. I just don't know which pin to use. I thought about just drilling it out but if the pin is harder than the sight or the barrel then the bit could go through at a bad angle causing me more problems.
Thanks in advance,

Link Posted: 10/16/2004 8:12:17 AM EST
[Last Edit: 10/17/2004 8:28:45 AM EST by IronBack]
On my SLR95 I knocked the pins out left to right. Take a close look at the pin. You can usually see a mark on the side they hammered on. Hope this helps.

Edited cuz I can't count.
Link Posted: 10/16/2004 5:27:21 PM EST
Ok that's the way it was on this one also. I had to knock the snot out of it but I finally got it. Those are some stubborn pins.

Thanks
Top Top