Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
BCM
Member Login

Site Notices
Posted: 1/24/2009 6:27:36 PM EST
How long did it take them to mail it to you?  I've been waiting a while so maybe they are wading through alot of bad disco's?
Link Posted: 1/24/2009 8:58:11 PM EST
Nobody?
Link Posted: 1/24/2009 9:31:34 PM EST
the tapco trigger? I would think that they are in stock and not a long wait... should ship in a couple days at the most.
Link Posted: 1/24/2009 9:45:08 PM EST
I've got a couple that are over drilled, but I've got better things to do than wait. I'm just going to JB weld 'em and redrill to spec. Good luck on your returns.
Link Posted: 1/25/2009 12:37:53 AM EST
I have not read about delays, but then again, they
may not be posted...yet.

I bought one off the EE right before this was discovered, and
my builder has it now. I hope its OK. I know it will be covered
by warranty, just dont was the delay. However long it is.

I will take the wait though before I use JB. Thats just me though.
Link Posted: 1/25/2009 6:01:14 AM EST
I got one from a gun show that was overdrilled.  I just took 10 minuets and made a small spacer that fits tight in the hole.  Works fine, no chance of it ever falling out.  I'd rather shoot than wait.
Link Posted: 1/25/2009 3:04:09 PM EST
I GOT 2 NOW FROM STOCKYS WENT SMOOTH  sorry bout the caps waiting on installing other one for retainer plate
Top Top