Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 2/14/2006 4:32:35 PM EST
I welded it back up and nursed it through the rest of the front trunnion rivets. I was able to add a lot of weld to the sides of the jaw since making it thicker didnt change the clearence needed.
I could not get the rearward lower swell head rivets to sink in the receiver good. What is the trick to this? This will be an underfolder so i have plenty more swell heads to do on this.
Link Posted: 2/14/2006 5:04:06 PM EST
I broke mine too. Welded it up just like you did. I think it's stronger now. I tryed to break it again and couldn't.
Link Posted: 2/15/2006 6:23:41 AM EST
Did you dimple the receiver for the swell necks?

Link Posted: 2/15/2006 8:00:30 AM EST
i snapped a set of 18" and 36". My latest pair of 36" is holding strong.

I think the 18" were too thin where i gorund them down. I think the first set of 36" got a little hot when i was grinding. Me last set, i quenched every few seconds to keep the temp to where i could hold them in my hand comfortably.

Link Posted: 2/15/2006 9:20:28 AM EST
most of the time they snap, is because they've been bottomed out on the trunnion, they'll still work fine though after you weld them up, I snaped mine, welded them up and have done four kits with them since.
Link Posted: 2/15/2006 2:58:10 PM EST
I broke my 18" set on the first rivet.
I fabbed up a 24" set and have not had a problem since.
Top Top