Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
PSA
Member Login

Posted: 12/16/2006 7:33:20 PM EDT
So, I think I'm gonna buy a few flats in anticipation of future products, but I see that you can get them with or without trunion holes... Would it be safe just to get all of them WITH trunion holes or is there too likely a chance that they wont fit any parts kits I later buy?
Link Posted: 12/17/2006 4:38:46 AM EDT
It is very likely that you will have to elongate the holes if you buy predrilled flats. Some people don't like to do that, so the undrilled flats are available.
Link Posted: 12/17/2006 6:20:29 AM EDT
The alternative (if you are or have access to a good welder) is to remove the rivets then weld the holes and grind the surface of the trunnions level.  Use the holes on a pre-drilled flat as templates for the new rivet holes you drill into the trunnions.  It takes a but more time but guarantees the best match-up between receiver and trunnion and no "egged" holes.

HTH
Link Posted: 12/17/2006 8:36:36 AM EDT
[Last Edit: 12/17/2006 8:37:26 AM EDT by dalesimpson]
Link Posted: 12/17/2006 9:15:17 AM EDT
No holes.  Different trunions have them in different spots.  What if you get a sweet deal on a chineese barrel assembly in the future ? Then your holes are all wrong.
Link Posted: 12/17/2006 4:07:02 PM EDT
My vote goes for no holes.
Link Posted: 1/2/2007 6:11:33 PM EDT
No holes wins the day. Thanks for your input guys.
Link Posted: 1/2/2007 6:48:42 PM EDT
Does the no hole plan also include 100% receivers, should they also be purchased without holes?
Link Posted: 1/2/2007 8:20:28 PM EDT
for the most part yes no holes is the way to go on the 100% also
dci makes some that are rifle specific and are close still need alittle fitting but they do take less work
Link Posted: 1/3/2007 1:10:37 AM EDT
No holes is still the way to go. It's a little more work but when you are finished you have a better product. IMHO
Top Top