Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 3/7/2006 6:12:00 AM EDT
Finished putting Romy G kit together last night. I still need to file some on the rails to get the bolt a little smoother.
My problem is: The bolt is just hitting the center support as it cycles. Should I file the center support a little????
Second problem is: When I pull the bolt back about half the time the hammer doesn't lock down. I have a Tapco double hook in it. Any ideas?

Thanks
Link Posted: 3/7/2006 7:28:43 AM EDT
You can take a little off the top of the center suport to make it cycle smoother. Some center supports have a flat spot just for this reason. Also, is your hammer installed correctly? Often peole install it backwards, and that will cause it to not catch.
Link Posted: 3/7/2006 7:47:09 AM EDT
I'll do a little grinding on the center support then. I didn't want to do it without asking to make sure it wouldn't screw anything up.
I'll double check the hammer but I'm pretty sure I have in the correctly. I have a single hook in my sar-1 maybe I'll switch them out and see if that helps.
Thanks
Top Top