Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Posted: 12/1/2005 3:53:16 PM EDT
[Last Edit: 12/2/2005 8:15:44 AM EDT by notso]
I go a wire sidefolder they had at the shop where I work. The latch stuff was in a bag along with it.

How do I get ti assembled? There is the stock, a U-bent sheetmetal piect that slides onto the rear of the lockin block, a spring that looks like a shillouete, a screw, catch and a lever thing.

Any Ideas?

EDIT: How much are these things worth?
Link Posted: 12/1/2005 4:36:19 PM EDT
Ok, looks like it is a E. German Floder with the thumb lever.

How does it go together?
Link Posted: 12/1/2005 4:42:23 PM EDT
This pic of mine might help clear some things up. The square hole on the bottom is where the grip screw nut goes in. You'll have to disassemble the insert, put the nut in, then reassemble. You might also have to thin it out a bit to get it to fit into your existing receiver. Have fun!

Link Posted: 12/1/2005 6:22:12 PM EDT
Thats just what I needed, thanks.

How much do these go for usually?
Link Posted: 12/5/2005 3:28:02 PM EDT
$60 to $70
Link Posted: 12/16/2005 10:27:31 AM EDT
[Last Edit: 12/16/2005 10:28:27 AM EDT by adrock]
Hi, this is my first post here. I'm trying to figure out this east german side folder. I assembled the parts like I found in another post, but the little tab that keeps it open and shut is too short to engage the stock base. The parts all look new - no wear on them or anything - there's just no possible way that I can see for the little nub to stick up far enough through the hole. Does that make any sense? Help!

In the assembled pictures, you can see the little tab doesn't stick up through the hole I circled. I'm pushing it up as far as it will go. Am I missing a plunger that should sit on top of that or something? All the parts I have are what you see in the pics.


Top Top