Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 1/30/2006 3:21:51 PM EST
I noticed on K-VARs website that the barrels that come with the rear site bases are not drilled...for obvious reasons.

How hard is it to drill the base for a pin after you get the right head space.

What size bit.

Link Posted: 1/31/2006 5:58:34 AM EST
The pin is 7mm.

Good luck with getting it lined up with the slot in the barrel. Even though it is properly headspaced by you, does not necessarily mean that the value was the same when it was originally drilled it.

I am sure someone smarter and with more experience than I, have a better answer for you. Hopefully.
Link Posted: 1/31/2006 10:52:27 AM EST
Thanks for the reply Millsusaf...

I can't tell if the barrell is already drill too.

I can see what you say about lining them up.
Link Posted: 2/5/2006 4:35:06 PM EST
Any other takers?
Link Posted: 2/5/2006 7:41:06 PM EST
[Last Edit: 2/5/2006 7:42:03 PM EST by R-32]
never mind, I misread your post...

I will think on it and come back with an idea.
Top Top