Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 8/7/2005 5:24:30 AM EDT
Are there any jigs to add the magazine well dimple, specificly to add the magazine well dimple to WASR-10's?....
Link Posted: 8/7/2005 5:47:08 AM EDT
They got to you too!

I'd say it wouldn't be worth the trouble, you'd have to take the "mag plates" out on the inside before you did anything. Be proud of your underdog...
Link Posted: 8/7/2005 6:44:41 AM EDT
I don't have one, I was just thinking if theres away to add the dimples to a WASR it would be a cheap way to get a correct AK, essentually turning a WASR into an SAR....
Link Posted: 8/7/2005 9:31:26 AM EDT
i was thinking of building some
but to use them on a wasr isnt worth it
i was going to build some for use on a saiga
doing a $750 ruaaian clone its worth it
to raise the value of a wasr 50 bucks just isnt worth the time
Link Posted: 8/7/2005 12:58:43 PM EDT
I just added a couple of thin plates inside of the reciever to take up the slack.
Link Posted: 8/7/2005 12:59:02 PM EDT
Except with a WASR if I want to clone an AK all I need to do is go to the store get a WASR and put in the dimples, with an SAR first I have to find it then order it, then go through the transfer dealer, pay shipping, wait, then have to take it to a gunsmith to get de-neutered, money isn't the issue it's convenience....
Link Posted: 8/7/2005 5:01:17 PM EDT
Link Posted: 8/7/2005 5:47:34 PM EDT
I don't have machineing equipment, does anyone sell one pre made....
Link Posted: 8/8/2005 4:29:38 AM EDT
A guy used to make them for around $30.00 but I haven't heard or seen a post from him in ages. I bought 2 of them and they work quite well.

BUT...you can't use them on a receiver that already has the magazine well cut. During the forming process metal is displaced in the mag well area. So, if the mag well area hasn't been cut you just push the metal back. Very, very hard to do with the mag well cut.

If you do a search at Gunco.net you will find the info about these dimple dies.
Top Top