Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 8/3/2009 6:24:15 AM EST
Can u cut down an ak barrel Thanks
Link Posted: 8/3/2009 6:34:15 AM EST
yes... (hopes OP realizes sarcasm)

just to let you know, allthough i don't actually know the answer to your question, people are probably going to ask you to elaborate on what you're asking. namely, why cut the barrel? to what length. the law normally regulates the minimal length of a rifle barrel, anything smaller than that lenght is either considered s different classification of a weapon or just plain illegal. my first suggestion would be to check with your state law (or is it federal? i'm the worst pre law tudent ever...) to see what the min length is.
Link Posted: 8/3/2009 7:21:19 AM EST
Link Posted: 8/3/2009 9:48:14 AM EST
I just wanted to cut it down and get the flashhider pinned so it's exactly 16 inches I've had an ar one done but I'm ordering a underfolding ak and want it to be as short as possible. And also will the American made black plastic grip fit on any ak?
Link Posted: 8/3/2009 10:38:58 AM EST
If your AK is the standard stamped receiver AK and not a Yugo and not milled, the black pistol grip will fit.


Also, yes you can chop the barrel down and permanently attach a muzzle device. I suggest you have a qualified gunsmith do it though. You might have to search around though and you most likely will have to send it off. A lot of gunsmiths are nazis when it comes to anything AK related.
Link Posted: 8/3/2009 11:02:22 AM EST
Besides the whole under 16" thing and depending on how much length you reduce, you will probably have to widen the gas port hole in the barrel to keep reliability up to par.
Link Posted: 8/3/2009 5:43:39 PM EST
U guys think they can cut the cleaning rod too haha so it will fit
Link Posted: 8/3/2009 5:55:41 PM EST
Originally Posted By chad43:
U guys think they can cut the cleaning rod too haha so it will fit


Actually my SLR107UR came with short cleaning rod but you do not mount it on the rifle.
Link Posted: 8/3/2009 6:50:07 PM EST
What length of cleaning rod came with your 107UR? I am trying find a shorter cleaning rod for a AK-102.
Link Posted: 8/4/2009 5:54:18 AM EST
Anyone know if I can get the cleaning rod cut the same as the barrel
Link Posted: 8/4/2009 5:57:25 AM EST
Link Posted: 8/4/2009 7:00:54 AM EST
M92 w/ a custom flash suppressor



Your not a traditionalist, there is no reason for a cleaning rod. Akalvarez is, thus hes looking for a cleaning rod.
Link Posted: 8/4/2009 12:23:59 PM EST
Im having adco do it I really like the cleaning rod on it I took it out of my other one and I didn't like it
Link Posted: 8/4/2009 2:52:47 PM EST
Link Posted: 8/4/2009 4:28:02 PM EST
The barrel on an AK is barely over 16" as it is. Just remove the slant brake and install a US-made barrel nut instead.
Link Posted: 8/4/2009 4:34:10 PM EST
It's gonna be the most expensive 1" reduction in OAL in history, but since it's your money, go for it.
Link Posted: 8/4/2009 5:08:49 PM EST
Brazos's





Looks pretty close to what you want.
Top Top