Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 9/25/2005 8:26:16 AM EDT
[Last Edit: 9/25/2005 8:30:23 AM EDT by cajunboy]
Picked up a chinese drum and I have difficulty seating it in the magwell of my MAK. It goes in but it requires a bump and another bump to get it out. Is this normal? The MAK has no problems accepting any other mags or my Romanian drum.
Link Posted: 9/26/2005 3:17:26 AM EDT
It is not normal but as long as it works?
If it bothers you then there must be a burr or some place a little on the wide side that needs a little sandpaper on it.
Link Posted: 9/26/2005 4:26:00 PM EDT
I have yet to try it. Hopefully I will get to do that this week. I figured it just needed a little sanding in some places.
Link Posted: 9/27/2005 5:42:20 PM EDT
Dont sand on your drum unless you know for sure where the problem is and what it is.
Link Posted: 9/27/2005 7:07:35 PM EDT
Tried it out today and it worked fine. No more problems with fitting at all. It did take a chunk out of my finger when I released the tension on the spring. Guess that is a lesson learned the hard way.
Link Posted: 9/28/2005 10:22:22 AM EDT

Originally Posted By cajunboy:
Tried it out today and it worked fine. No more problems with fitting at all. It did take a chunk out of my finger when I released the tension on the spring. Guess that is a lesson learned the hard way.



That'll happen...

Sly
Top Top