Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 4/2/2006 11:04:29 AM EST
Has anyone here used the C-Clamp method to bend receiver flats? If so what c-clamps did you use? And how well did it work?
Link Posted: 4/2/2006 12:25:04 PM EST
Good luck with that! Your best bet is to get or borrow a bending jig and a 12 ton press. I know from past experience that that would be the easiest method. I have ruined 6 TAPCO flats screwing around , you can figure out the cost on that little experiment. ( it'll make me cry to think about it )
Link Posted: 4/2/2006 4:06:13 PM EST
I bent my first flat using a 555th jig and 2 c-clamps. I would strongly recommend that if you are going to use c-clamps to bend your flats using a flat bending jig that you use 3 clamps and not just 2. When I was bending my flat one of my c-clamps kind of exploded from me putting too much force into it and when I finished it with 3 clamps it went much better.
Top Top