Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 8/20/2003 8:02:18 AM EST
[Last Edit: 8/20/2003 5:21:16 PM EST by HSimpson]
I'm trying to figure out where to bend the top lips/rails for my 80% receiver. It's the Hesse flat from JoeKen. Can somebody please give me a measurement from a point on the side of the receiver like a trunnion rivet hole or an axis pin to the crease? Or, the width of the rail on a stamped AK?

My plan is to first bend the upper lips, then fold the sides up. For folding the sides I went to Home Depot and picked up a 1 1/4" metal flat. I drilled it to bolt to the botton of the receiver. Had to grind out a little depression for the ramp that protrudes down forward of the mag well. Also radiused the metal a bit where the mag dimples are for clearance. I intend to bolt flat steel to the sides before folding so that I don't warp the metal.

Any help or tips welcome and greatly appreciated!
Link Posted: 8/21/2003 3:09:29 AM EST
[Last Edit: 8/21/2003 4:23:46 AM EST by CAMPYBOB]
Link Posted: 8/21/2003 12:05:28 PM EST
Thanks. I looked around for a decent SAR but gave up after seeing five crappy ones. Guess I need to go take a closer look.
Link Posted: 8/22/2003 2:16:45 AM EST
Top Top