Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
PSA
Member Login

Site Notices
4/1/2020 6:58:51 AM
Posted: 1/13/2005 12:35:43 PM EDT
Hello Everyone,
I want use rivots on my amd-65 build. Do I need to remove the barrel from the trunnion or can i drill holes where the old rivots were and then insert the new rivots? If I do have to remove the barrel, Does the barrel pin just press out or do I have to grind off one of the ends of the barrel pin?
Thanks
Link Posted: 1/13/2005 1:28:47 PM EDT
You have to remove the barrel as the rivet process is done withe barrel out of the trunion and the barrel pin will need to  be pressed out, If I remember you need to press from the left side so it comes out the right side
A shop press is recomended but some people have had luck using a large vise and the general concencuss is the pin is a bugger to get out.
Top Top