Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 4/6/2006 5:25:05 AM EST
I've kinda gave up on building my own. I've got the parts kit demilled and was set up to do a screw kit but my first attempt on my reciever is a hair too narrow. Then I found that my local gunshop has complete recievers for $90 without truinon holes.

I've got several templates for the recievers. How do I get the correct hole placement for the truinons? The kit is a romy.

Is the reciever for a pistol kit the same?

Is it legal to build your own pistol?

thanks
Link Posted: 4/6/2006 9:19:45 AM EST
the holes are diff on almost every ak even 2 aks from the same country

thats why people drill there own holes

a tacked thread at the top will show you couple ways to find where the holes go

Link Posted: 4/10/2006 7:20:14 AM EST
Thanks candyman

I have a screw kit that I don't know where I got it from . It has 2- 10-32 screws and I couldn't remember where they're suppose to go. I believe the rest are 8-32s. I know I've seen it on a site somewhere but could someone refresh my memory?
Link Posted: 4/10/2006 4:36:02 PM EST
The 10-32'nds are for the trunions, the 8-32'nds are for the trigger guard.
Link Posted: 4/11/2006 12:58:58 PM EST
the receivers should physically be the same except for pistol markings on pistol rec. as far as i know if you havent been convicted of a felony or violent crime you can legally build a gun, but only if it meets other law requirements like 922r and g.c.a. ect.
Top Top