Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 12/16/2005 12:57:29 PM EST
I'm new to building AKs, and I'm starting out with a Romy, but I ordered a Polish U/F kit for the future. Does anyone make 100% receivers for these with the rear trunnion cut-out?

Link Posted: 12/16/2005 1:08:26 PM EST
Dph arm had ones made by ewbanks,with all holes.And the pistol grip plate(for added strengh)
Link Posted: 12/16/2005 1:09:21 PM EST
I'm pretty sure Scott at DPH Arms has them. I think they are JOEKEN receivers. Some people on this site have issues with JOEKEN. I have no experience with them either way so I can't comment.
If you order one and do a build, please let us know how it went. I'm interested in building a Polish folder myself.
Link Posted: 12/16/2005 1:32:18 PM EST
Global Trade has one that is not listed on their website or anything.

You have to talk to one of the ladies and request it. It adds $50 to the cost of the receiver.

Link Posted: 12/17/2005 7:58:10 AM EST
[Last Edit: 12/17/2005 7:58:46 AM EST by Muskrat]
DCI/Harlan is probably going to make a Polish underfolder receiver that would be better than any currently out there. They could be offered as early as late January. I'm holding out for theirs.

Link Posted: 12/17/2005 10:25:13 AM EST
Built this with one from DPH....worked out very well.

Link Posted: 12/18/2005 9:20:43 PM EST
Just don't forget to see if it has the reinforcement plate. If it doesn't, you should add one.
Link Posted: 12/19/2005 6:06:52 AM EST
How hard is it to drill underfolder holes in a Tapco flat? Is it just a matter of getting a templete and drilling?
Link Posted: 12/19/2005 12:19:24 PM EST
If its intact you can use the old rec stbs as a template
Link Posted: 12/20/2005 3:20:46 PM EST
Beautifully done. I have a kit that I did on a cold steel blank that will be awaiting a correct receiver from Harlan. The coldsteel blank had many problems which the locked up bolt carrier was one too many. Cut up the receiver witha bandsaw to demill it permanently and stop the waste of time on that one......

Originally Posted By TerryG3:
Built this with one from DPH....worked out very well.


Top Top