So I have decided that the pillars I add have not solved my flyers... So I have decided to fully bed the action to the stock.
This is a bit of an undertaking as the Ruger using bedding blocks. I have decided not to permanently mount the blocks to the stock, but allow then to be removed.
I started out by removing the pillars. Luckily this went better then I expected, probably due to using JB weld.
Then off to the hardware store for new pillars and longer action screws.
The goal is to have them stick out past the stock. so later, once everything is set up, I can trim them down to where I want.
I started to route out inside the stock and found a few spots where the wood have been up against where the barrel and action meet. Could be the source of my inconsistency...
I have decided to go with Devcon 10110. As I want this to be as strong as possible. Iwill need to add grooves to the pillars and finish off routing out and masking off the stock... stay tuned.