@mbf11
Hey Mike, a quick question please?
Regarding your REs ( ZM42929-6).....description states "
Mil-Spec diameter ". Obviously per the Mil Spec there is a +/- variance allowed, do you folks concern yourselves with targeting either end of the tolerances or just ensuring that you fall inside the spec?
We all know that mixing/matching components at times results in mixed fitments, as one stock may fit tight and another loose, no new story there.
Do you purposely offer a slightly oversized carbine RE for those wanting a tight fit between stock body and RE?ETA: Not to say that your REs are oversized, just looking for info as to whether or not you offer one specifically machined oversized.
EDIT 2:
I did find
THIS BROWNELLS LINKstating " approximately .003" oversized/Mil-spec 1.145" to 1.150” O.D.".....so is that to say these will measure .003" larger than either/or end of the spectrum (low/high)? Or .003" above the high end of Mil Spec?
Also, is this a Brownells exclusive item not sold on your page? Because I've yet to see it.
Tig