These are the Gen 2 Mod 3 non-rotating trigger/hammer pin sets are the toughest pins produced. KNS designed these pins to withstand the stresses generated by high-impact suppressed fire. Our trigger & hammer pins are stainless steel and our retainer side plates are steel with a black nitride finish.
Our KNS non-rotating trigger/hammer pin sets prevent wear on your AR lower and prevent your pins from walking out of your receiver.
This kit includes an installation guide tool & 2 Torx wrenches. No permanent modification to your gun is required. These are the half-round style side plates similar to our Gen 2 pin sets.
Torque spec for screw-tightening should not exceed 11 inch-lbs, 8 inch-lbs is recommended.KNS GEN2 NON-ROTATING TRIGGER/HAMMER PIN SET FOR AR15, $27.00https://www.robertrtg.com/store/pc/KNS-GEN2-NON-ROTATING-TRIGGER-HAMMER-PIN-SET-FOR-AR15-6p9538.htm
Thanks for looking and happy shooting!
931 Frank St.
Sheridan, WY 82801
Email: [email protected]