Selling three different LR-308-pattern parts. Shipping will be via USPS. Preferred payment is USPS money order. Can take discreet Paypal F&F as long as you don't put anything in the message section.
First up is a Tactical Machining 80% DPMS-pattern lower receiver. This is the original .308 80% receiver they made, not the TM 10.2 version. Current retail on this is $190, but they're almost never in stock. Comes with the two set screws and small metal bar needed to complete the build. Asking
$180 $170 shipped.
Second is a Blackhole Weaponry 7mm-08 DPMS-pattern barrel. Length is 24", twist is 1-10, rifle length gas, .097" gas port, profile is bull barrel. I installed this on an upper, never completed the lower and this sat around unfired for a few years. A little bit of grease on the barrel extension and expected storage wear, but otherwise as new. Comes with a .936" gas block and knurled thread protector as seen in photos. Barrel is threaded 5/8-24. Gas block has brass marks on the right side from the brass hammer because I didn't have roll pin punches at the time I put the upper together. Barrel is not dimpled for gas block set screws, screws were merely tightened onto the barrel. Stamps on barrel read BHW Z 7MM08 1x10 SS P3 2902. Asking
Third is a DPMS LRT-SASS quad rail handguard. You can find details at Midway's site, as these are now discontinued: https://www.midwayusa.com/product/100332974
DPMS low pattern. Weight is approximately 17 ounces. It will leave a rifle length gas block exposed. Underside has a slot milled out that looks like it would allow set screws on a midlength gas block to be tightened. Same story, installed on upper, sat around unused for years. In great shape. Comes with barrel nut and lock ring, a little grease from installation left on the nut. Asking
$200 $180 shipped.