Daniel Defense DDM4V7  Texzs / DPS Edition ,  NIB in DD hard case just as it came from DD. as follows:
LOWER RECEIVER: Mil-Spec with Enhanced Flared Magazine Well and Rear Receiver QD Swivel Attachment Point. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized
•  UPPER RECEIVER: Mil-Spec with Indexing Marks and M4 Feed Ramps. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized
•  BARREL: Chrome Moly Vanadium Steel, Cold Hammer Forged, 1:7 Twist, 16" Government Profile, Mid-length Gas Swivel Attachment Point. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized
System, Chrome Line•  LOWER RECEIVER: Mil-Spec with Enhanced Flared Magazine Well and Rear Receiver QD d, Mil-Spec Heavy Phosphate Coated, and HP/MPI Tested
•  GAS SYSTEM: Pinned Low Profile Gas Block CNC Machined of 4140 hardened steel and Mil-Spec Heavy Phosphate Coating, Mid-length, Direct Impingement
•  MUZZLE DEVICE: Daniel Defense Flash Suppressor, 17-4 PH Stainless Steel, Salt Bath Nitride Finished
•  BOLT CARRIER GROUP: M16 Profile, Mil-Spec MP Tested, Chrome Lined, Properly Staked Gas Key
•  BUFFER: H Buffer
•  SIGHTS MBUS PROs
•  HANDGUARD: Daniel Defense MFR 15.0, CNC Machined of 6061-T6 Aluminum, M-LOK Attachment, Type III Hard Coat Anodized

This has ALL the usual V7 mods but the Texas Edition adds over $500 in extras to include, MBUS Pro sights, MagPul sling, Troy ambi mag release, MLOK rail cover sections, Radian Raptor charge handle. I have 2 of these with consecutive serial numbers,   $1600 each .$1550 each shipped

payment by Postal MO or major bank cashiers check.   All sales will go thru an ffl. Running on ultiple forums. Thanks for looking.

Please send pics

hows about both for $2800 ??

Le6940 trade,  interested? Like new

Trade for my LE6940 in like new condition.

looking to sell outrigh, thanks for the offer in any event.

Where at in Texas.  I’m interested if they are still available.  Msg me if they are

Have messaged you twice over 2 days?
If not interested please have the courtesy to
Say so.