****Listing has been revised to include a few more items and add a flat shipping fee****$4.00 Flat shipping fee no matter how much you order. All prices are PayPal F&F or you cover the fees
Everything designed, tested and 3D printed by myself.
The plate holder has provisions for 4 Dillon case feed plates. Designed to fit 1 Small Pistol, 1 Large Pistol (including the washer they give you as a spacer for some calibers), 1 Small Rifle and 1 Large Rifle plates. ***CASEFEED PLATES ARE NOT INCLUDED***
The storage plate has non-skid feet on the bottom so its not going to move around. $16.00 EA
The case feed plate knobs aid in installation and removal of the plates themselves from the motorized unit. I never realized how hard it was until I started using these add-on knobs. They simply sandwich between the bolts and the plate using the existing hardware. Take the 2 bolts out, put them through the knob and tighten back down. The case feed plate is still fully adjustable for slippage. $1.50 EA
Dillon 650/750 tool head stand / conversion kit combo holder. Everything you need for a caliber conversion in one convenient place. Comes with caliber specific name plate (You tell me what you want it to say) that can be glued to the stand or the tool head itself. Tool head "peg" printed separately for ease of shipping and must be glued in place. Stand has non-skid feet attached. $15.00 EA or 3 for $40.00
Dillon primer tube stand. Holds a total of 10 tubes, large or small, in any combination. wide base prevents tip-over. Non-skid feet attached to the bottom. If you use a vibra-prime system and have removed the pick-up end of the tube....I can print caps to fit over the ends like shown in once of the photos. Please note:
Due to variances in the plastic tips from Dillon some tubes may not stand up perfectly straight and may have a slight angle to them.$7.00 EA + $1.50 for 10 caps if needed
Dillon powder dispenser adjustment knob. Makes adjusting the powder tool-less. Slim profile so it doesnt interfere with anything else. This a press-on fit. Its not recommended to continuously remove and re-install. Works with both the small and large powder bars.
I can pint these in almost any color, as long as i have it in stock. If your interested in a color I don't list below, please email me to discuss.
Colors available: (see photo below for true colors)
BLUE"DILLON" BLUEBLACKREDORANGEGREENWHITEGREYSILVER METALICPURPLE
The "Dillon" Blue actually matches very close to the color of actual Dillon products and what's shown in the photos below. I also took a photo of one of the plate knobs on my Dillon Press so you can see how close it matches color wise.*****Email me for fastest response to questions or orders*****