AR 15 Rear take-down Pin detent spring MODIFICATION Kit (
5 2 Available)
Tired of launching the rear take-down pin spring when removing the receiver end plate? Then this kit is for you.
This is a very simple modification which can be completed in a relatively short period of time.
If you are careful you can modify 3 receivers.
Included in the kit:
•Hand tap (1) piece
•Cone tip socket head set screws (3) pieces
The cost is $ 20.00 NET to me shipped CONUS, PayPal preferred.
Post in the thread “I’ll take one” followed by an email.