Been reading and doing my best to learn as much as I can but I'm sure I'm missing many of the finer points to this project. My buddy and I are building AR10's from 80% lowers. Going to build his first (or attempt).


For his build we started with a 80% arms lower and GEN2 Jig:

https://www.80percentarms.com/products/raw-billet-308-80-lower-receiver/

https://www.80percentarms.com/products/easy-jig-gen-2-multi-platform-ar-15-ar-9-and-308-80-lower-jig/


For the upper we went with the PSA Gen3 PA10 20" Rifle-Length .308 WIN 1:10 Stainless Steel 15" Lightweight M-lok

and for the lower build kit we went with the PSA PA-10 Classic Lower Build Kit


I think that's going to keep us busy for a while once all the parts show up! Any links or advice is greatly appreciated! Thank you!

For my build we're starting with an 80% lower from Right to Bear Arms:

https://www.righttobear.com/Forged-DPMS-Pattern-80-percent-raw-308-lower-p/80raw-308-dpms.htm

Any suggestions for an upper that will match the lower well? (Not sure where the forging comes from)