I was wondering if there were any tools, or improvised tools for magazine catch rivets.
Just wondering whats out there for a better looking rivet flare/factory look.
I already purchased the robert forbus flaring punches for the gas tube lever/hg retainer.
I used roll pin punches, a combination of a ball bearing/flat punches for flaring the rivers
A vise, etc.
Just wondering if anyone makes a tool similar to an AK sight tool, but a bit bigger to work for the trigger guard rivets.
I wouldnt mind the DIY approach.
My thoughts/Idea
Basically I would enlarge a ak sight tool, and modify the screw part to better flare out a rivet
As for the hole these have for the sight drum. I would just cover it with a coin that was ground flat (to remove any markings)
The coin would act as a non marring anvil while the screw flares out the rivet.
For those being sticklers about defacing US currency it could be a Chucky Cheese token lmao.
What are you guys using? I just want to be able to install this while making it look half decent.