i ordered a few blems that were on sale (30.00 each) two of the three had very tiny blemishes, but the third looked like a monkey had sanded the side.
i didn't think too much about it because it was cheap and shouldn't hurt the functionality.
well i didnt notice the detent hole for the pivot pin was drilled too high.
that makes the pin crooked.
this sucks because i already milled out this lower.
so the moral of the story is always double check your lowers. although i could have stared at this one for days and probably not seen that the pivot pin detent hole is a few hundredths off.
i wanted to post this because i had not seen this problem before.
honestly, i am just going to sand the pin so it fits flush against the receiver. it will most likely become my truck gun/ steel shooting beater gun. (i know shooting steel has no effect on the lower)