My 308 barrel is due for a swap out on my Rem700. I've looked a lot at the Remage barrel kits and am ready to take the plunge. Anyone in southern NV have the tools to remove a factory barrel and install the new one. Will need 6.5CM go/nogo gauge, barrel vice, savage barrel wrench and 700 action wrench. The recoil lug has an indexing pin which will need appropriate notch milled into the reciever. I've asked some of the shops and they were hesitant.
Here's a good article covering what's required
http://rifleshooter.com/2015/03/rebarrel-a-remington-700-without-a-lathe-mcgowen-remage-barrel-converison/