FS: Gently used Eagle Arms/ Armalite AR10 (not a factory build) 20" rifle. Eagle Arms lower receiver was purchased as a blem with the bolt catch pin hole not drilled and a large amount of forging flash on the rear of the receiver and inside the trigger guard area. Flash was removed and the areas touched up with AlumaBlack (splochy finish shown in pics). The bolt chatch pin hole was drilled and it functions 100% (gen 1 bolt catch works with old or new mags). Barrel was turned and chambered from a Kreiger blank, if I can find the serial numbered cut off end of the blank I will Include it. The rifle was built by me (Colt LE Armorer), for me. Rifle is a sub MOA shooter with FGMM and Black Hills 168grn/ 175grn loads and an experienced shooter behind it. I'm only selling the rifle to enhance my duty firearms and equipment, price is firm at $1450 shipped to your FFL, trades are listed below. Prefered payment is by USPS MO or cash on a FTF transaction, trades will be plus cash.

20" stainless steel (416 I think) Kreiger barrel threaded 5/8x24 w/ A2 flash hider, .850 gas block, less than 300 rounds fired
Armalite carbon fiber free floating handguard w/ bipob stud
Armalite BCG, flat bottom style
Armalite charging handle w/ Badger Tac Latch
Rock River Arms match trigger preset @ 4.5 lbs
KNS Gen 1 hammer/ trigger pins
MagPul trigger guard
MagPul Gen I PRS stock
Sierra Precision SPR grip (right hand only)
1 10 rd mag
3 20 rd Gen1 preban mags
bore guide
lower receiver block

















Trades:
S&W M&P .45 no thumb safety or magazine disconnect
quality Level 4 Esapi plates 10"x12" swimmer/ shooter cut
new model EoTech sights (single battery type)
Trijicon RMRs with smaller MOA dots (dual illum prefered)
AICS Rem 700 SA w/ folding stock
Springfield Armory TRP with rails

Would you sell just the upper?

one last bump