ARCHIVED
 bags533
Two thirds of the way to being fat, dumb and lazy.
Team Member
Joined: Oct 2008  MS, USA
 
 Posts: 2189 Feedback: 100% (5) |
Posted: 8/16/2012 8:29:07 PM
[Last Edit: 8/16/2012 8:31:13 PM by bags533]
THE IMAGE ABOVE IS A PAID ADVERTISEMENT Spent all afternoon looking at videos/reading about how to take it apart and put it back together. I think I did the reassembly correctly, except the bolt sticks out of the back about a 1/16" from the receiver- it's not flush as I thought it should be. Is this normal?? When I cycle the bolt it works fine, and fires. But I didn't pay attention to see if the bolt was like this prior to disassembly. I also couldn't get the LCI pin out with a magnet or pliers- any other suggestion? I had to whack it a few times with a rubber mallet during disassembly/reassembly- I hope that gets easier. Thanks for you kind replies to a tired subject. 
|
|
|
bags533
Two thirds of the way to being fat, dumb and lazy.
Team Member
Joined: Oct 2008 MS, USA
Posts: 2193 Feedback: 100% (5) Link To This Post |
Posted: 8/17/2012 9:22:33 PM
Disregard- I finally saw a few pics where the bolt is not flush with the receiver.
|
|
|
|
Posted: 8/22/2012 12:30:34 AM
It will loosen up after a while, just keep shooting!
Try squeezing in on the LCI a little bit when you are trying to get the pin out. Doing that along with a strong magnet gets it out every time for me. |
|
|
|
bags533
Two thirds of the way to being fat, dumb and lazy.
Team Member
Joined: Oct 2008 MS, USA
Posts: 2211 Feedback: 100% (5) Link To This Post |
Posted: 8/22/2012 8:14:54 AM
Thanks, I got it out with no problem once I squeezed the LCI. I also put in Bam's bushing, and it's really nice now.
Still gotta bang the crap out of the grip to get the barrel/receiver to sit correctly. |
|
ARCHIVED
