 HunterGren 
Member
Joined: Jan 2003  USA
 Posts: 3354 Feedback: 100% (28) |
Posted: 2/19/2010 2:18:30 PM
THE IMAGE ABOVE IS A PAID ADVERTISEMENT |
|
|
|
|
Posted: 2/19/2010 3:59:49 PM
I'm guessing no, and that's what many others seem to be doing.
And also, someone jus mentioned today in another AK thread somewhere around here that the AMD65 Ultimak rail will fit the Draco if you just fiddle with the positioning, and lock it down without either end fully seated against the FSB/gas port, or the RSB piston hole. |
|
|
|
|
Posted: 2/19/2010 8:44:17 PM
I cut about an inch off a standard Ultimak to put on a Draco. 20min job. The AMD model will bolt right on. Its just about a half inch short. Will work fine but looks a little funny to some people.
|
|
|
|
|
Posted: 2/20/2010 10:17:01 AM
Cool, thanks. I didnt want to order one without knowing for sure.
|
|
|
|
|
Posted: 3/21/2010 9:21:34 AM
[Last Edit: 3/21/2010 9:24:35 AM by Mammynun]
I just put an Ultimak M1-B on my Draco. I had to cut off aroound 3/4" to get the length right. My "issue" was to get the contour/bevel on the inside of the front to fit... Harbor Freight has a 2-pack of step drill bits and using both in combination I was able to make it work. I put 250 rounds through it with know problems. It took me about 2hrs to complete, but most of that was me going really slow so that I didn't fuck it up. I haven't shot it wiyh the Primary Arm Micro yet, but a generic RD that I had laying around worked well. The Ultimak gets HOT after a mag or two, but I'm much more accurate and quicker with a red dot. I'll be keeping it! The Gen 1 Micro DOES co-witness with the Ultimak, at least it does on mine.
 |
|
|
ARCHIVED
