ARCHIVED
 |
Posted: 7/12/2012 10:58:44 PM
Thanks! Good eyes - however it is a 1" length of 1/2" fuel hose that I have pounded onto the charging handle. Makes the charging handle slightly "sticky" - so my hand won't slip off when wet/muddy.
cheers tire iron |
|
|
|
|
Posted: 7/15/2012 1:06:13 PM
Have a 1-3X on my M10 7.62x39.
I'm just trying it out with an inexpensive UTG side rail. The rail weights about 7 oz, which is typical for these rails. It fit great and locks up tight. Have not tested re-zero yet. I'm going to zero the rifle at 50 yds with the irons at 25M. I'm using the Burris Xtac low rings. (About 4 or 5 oz together IIRC) They are heavy but very solid! The scope only weighs 9 oz with lens protectors. This set up adds a little weight, but didn't hurt the balance of the rifle at all. It handles very nice and is not barrel heavy. The scope and mount remove very quickly and the dust cover can easily be removed without taking the scope off. I had to get a raised comb for the stock but I thought I would have to anyway. I was concerned about sight height but at 3.1 inches (center of bore to center of scope) it's not as bad as I thought it would be. I have not fired it for nice groups yet (five or ten shot) but plan to. |
|
|
|
|
Posted: 7/23/2012 1:04:38 AM
I run a posp 4x fixed scope on my converted saiga x39. I really like it. The BDC on the commie scopes work good, at least out the 300 yds I've ran it. My Gf can hammer a 24 inch gong at 200 yds without any trouble.
|
|
|
ARCHIVED
UT, USA
Posts: 220
