I was hoping someone would like to share some dimensions off of a Soviet pattern supperssor.  I am planning ok turning down my own 7" barrel extension for a M92 under folder build.  I'm doing it as a project to get more familiar with the Mazatrol programming on the Mazaks. Anything would be appreciated!

Background:
I am lucky enough to be part of a family of machinists that run our own job shop. Our POs cone from oil gas and water. Lots of stainless, inconel, Monel, with HT# and certs has accumulated and I am going to take some instead of scrap money this quarter. No titanium though. So, thought Id save $60 and turn something cool if not historically correct.

So if I'm reading this correctly you just want external dimensions to make a an extension to bring the barrel to 16", correct? You're not actually looking to recreate a Russian pattern suppressor 100%? If so, I could get you external dimensions of a Russian PBS-1.

Yo are correct.  No suppressors in IL yet.

Project is DONE.  Went generic with the "can".  Turns out suppressor manufactures don't give two shits about people in Illinois.  Go figure.