Site Notices
11/24/2014 4:59:23 PM
Author
Message
Bonr
Offline
Posts: 28
Feedback: 100% (1)
Posted: 7/3/2010 2:00:15 PM EST
[Last Edit: 7/3/2010 2:03:21 PM EST by Bonr]
While attempting to install a Badger Ordinance Tactical Latch I lost the roll pin. Can anyone tell me what size they are? I found a link on another post that had pin and spring sizes, but the charging handle roll pin wasn't listed. Also, can I just get some at the hardware store? or are they some specialty kind I need to get from a gun shop? I used a 1/16" punch it felt a bit tight going in, that is the correct size? Thanks.
ChromeLined
Offline
Posts: 5502
Feedback: 97% (98)
Link To This Post
Posted: 7/3/2010 2:09:20 PM EST
its a 1/16 roll pin its the same as the gas tube pin.
Bonr
Offline
Posts: 29
Feedback: 100% (1)
Link To This Post
Posted: 7/3/2010 2:16:58 PM EST
Originally Posted By ChromeLined:
its a 1/16 roll pin its the same as the gas tube pin.


So I can just pick a few up at the hardware store?
arrowheads
Member
Offline
Posts: 191
Feedback: 100% (54)
Link To This Post
Posted: 7/3/2010 2:19:54 PM EST
[Last Edit: 7/3/2010 2:27:31 PM EST by arrowheads]
yes you can get 1/16 roll pins at tsc or Lowe's just cut to size.

FYI... gas tube roll pins are 5/64 not 1/16


Originally Posted By Bonr:
Originally Posted By ChromeLined:
its a 1/16 roll pin its the same as the gas tube pin.


So I can just pick a few up at the hardware store?


Bonr
Offline
Posts: 30
Feedback: 100% (1)
Link To This Post
Posted: 7/3/2010 2:31:58 PM EST
Originally Posted By arrowheads:
yes you can get 1/16 roll pins at tsc or Lowe's just cut to size.

FYI... gas tube roll pins are 5/64 not 1/16


Originally Posted By Bonr:
Originally Posted By ChromeLined:
its a 1/16 roll pin its the same as the gas tube pin.


So I can just pick a few up at the hardware store?




Thanks.