Site Notices
7/29/2014 4:02:36 PM
7/28/2014 11:40:43 AM
Author
Message
Interceptor_Knight
Offline
Posts: 137
Feedback: 100% (3)
Posted: 3/6/2006 10:35:14 AM
I am not sure where this belongs, but I am looking for pics of the M-16 rifle mount brackets mounted in a vehicle or a pic of the instructions. I picked up a pair at the gun show Sunday, and it seems like there is something missing.
sgtmike
Offline
Posts: 323
Feedback: 0% (0)
Link To This Post
Posted: 3/6/2006 6:47:06 PM
Is it a two piece rubber kit with a butstock holder and a cradle with a heavy rubber strap?

Sarge
Black-Tiger
Offline
Posts: 254
Feedback: 100% (14)
Link To This Post
Posted: 3/6/2006 6:56:03 PM
Is this rifle mount a military surplus mount or the type of mount found in a police vehicle? What type of vehicle you intend to mount the rifle to? a Sedan? Pickup Truck? SUV?

Also, pics of the mount you purchased might give us some ideas on the appropiate mounting location will benefit you.
Interceptor_Knight
Offline
Posts: 139
Feedback: 100% (3)
Link To This Post
Posted: 3/6/2006 7:05:18 PM
[Last Edit: 3/6/2006 7:05:50 PM by Interceptor_Knight]
It is military surplus. Supposedly CUCV and M151. A square/rectangle buttstock bracket and a bracket with a spring loaded lever for the handguard area.
I will try and get pics.
303_enfield
Online
Posts: 28
Feedback: 100% (145)
Link To This Post
Posted: 3/6/2006 7:39:59 PM
Yep,GI issue. For M151(jeep) 998,1025(HMVVE).... Spring loaded part holds barrel not handguard. In the CUTVE(Blazer) they are mounted in the right rear seat area. 998,1025 front U(buttstock bracket) tight on right/left floornext to wall, spring clamp near heater vent. Rear passenger ones had a bracket mounted off the floor. Try to find a TM for a Hummer. The 151's we had, didn't have them. I had a M60 mount and a radio mount. Just test fit a AR in it and weld or screw it to the truck
ATB,
Chalmers
Interceptor_Knight
Offline
Posts: 140
Feedback: 100% (3)
Link To This Post
Posted: 3/6/2006 8:37:21 PM
Cool...thanks.
Black-Tiger
Offline
Posts: 257
Feedback: 100% (14)
Link To This Post
Posted: 3/6/2006 9:33:39 PM
THe rifle mounts on the HMMWV were originally designed to hold the M16A1/A2/A3 20 inch rifle; if you plan to use the mounr on a 16 inch CAR/Midlenght or an 18 inch SPR type rifle, you should custom mount the rack to a 1 inch wide piece of steel, weld or rivet the mounts in place and custom fit it to your vehicle; should be simple to do with some welding experience. add some military paint to it and you should be ready to go.

Hope you have fun.