I'm hoping to install a Phase 5 Tactical Extended Bolt release v2 308 EBRv2-308 on my OBR 7.62, but first I need to remove the existing bolt release...which raises the question: How?
The factory bolt release seems to be held in by a pin (since it doesn't appear to be a set-screw).....but frankly, I don't see it. I see the hole on the right (stock side) of the bolt release lever where it should be, but perhaps the pin is recessed so much that it's end is not visible from the hole on the right (stock side) of the bolt release lever.
And if it is a pin, how does one push it out, and back in? Because the lower has a raised area on the left (muzzle side) of the bolt release which would prevent access to the pin with a punch. The raised area has an open window however...so all I can surmise is that you use a punch from the right side, pushing the pin left to remove the bolt catch, and then insert something into the "window" to work the pin left-to-right to get it seated again?
If you've done this already, please advise! Thanks!